INTRODUCTION 1
The Martin DMX Interface converts DMX data into Martin data to allow you to
control an older, Martin-protocol-only fixture with a DMX controller. The DMX
Interface supports the following Martin products:
Note! A separate DMX Interface is required for each type of fixture.
The DMX Interface operates only one type of fixture at a time. It can operate
multiple fixtures of the same type. The table above shows the maximum number
of each fixture type that can be operated with a single DMX Interface.
PAC KAGE CONT ENT S
Please make sure that you received the following with your DMX Interface:
• 1 X Martin Professional DMX Interface
• 1 X Terminator Plug
Fixture Type Fixtures per Interface
RoboColor MSD 8
RoboColor 8
RoboColor II 8
RoboScan 804/805 8
RoboScan 1004/1005 8
RoboScan 1016 8
RoboScan 1020 4
RoboScan Pro 218 8
RoboScan Pro 1220 4
RoboScan Pro 1220 II 4
RoboScan Pro 1220 IIR 4
RoboZap 8
RoboZap MSR 1200 8
Centrepiece
http://www.theflea.org/tech/docs/martin ... erface.pdf
Jag har hört att det ska finnas någon liknande Dmux manick som omvandlar från martins gamla standard till DMX. Vet inte viken standard det är men en ledtråd är att det bara sitter 6 dips i stället för 10 (som på DMX). Mer info än så kan jag tövär inte ge 
